1 3
MTI  |  SKU: Die58-RC33

Split Dry Pressing Die for Ring Type Sample from 10 mm to 32.mm Dia. - Die-Ring-C

€0,00
Dimensions

Delivery and Shipping to EU

We will add in the quotation, the shipping, insurance, customs clearance costs.

Split Dry Pressing Die for Ring Type Sample from 10 mm to 32.mm Dia. - Die-Ring-C

MTI

Die-Ring-C is a customized drying pressing die for making annular samples.

SPECIFICATIONS:

Dimension of die
  • ID:    20 - 35mm ( +/- 0.01 mm )
  • OD:   40 - 70mm
  • Height:   25 - 50 mm
  • The customer must provide the drawing of the ring-type sample with tolerance for quotation
Materials
  • Cr12MoV
  • Hardness: HRC 60
 Max. Load
  • 350 MPa
Pressing die installation schematic

     
Instruction
     
        
Application Notes
  • To get the better density of samples, please considering using a cold isostatic press (CIP)
  • Small particles may slip into the gap between the pushing rod and steel sleeve and cause damages to the sleeve during the compression. We recommend using 32~75 microns powder to avoid damages.
  • Please consider using the 3'' Dia. Sieve Set No.200&450 Mesh to get 32~75 microns particles  
  • Please use alcohol to clean the pressing die every time before and after use
  • Store it in a dry place with antirust oil after the operation to avoid rusting.
  • For pressing sticky metal powders such as Al, Mg, Zn, it is necessary to use dry or alcohol-based lubricant to lubricate the die and sleeve set to reduce friction during the compression. 
  • Please must always wear protective goggles during the operation !!!
Warranty
  • Pressing Dies are consumable products and are not covered by MTI's warranty.


Related Products


Pressing Die  1/8" - 3"  		Laboratory Mill & Mixer
Powder grinding & Mixing 		Gravity Convection Ovens, Max. 300C
Drying Ovens
Calcining & Sintering
Hydraulic Press
CIP - Cold Isostatic Press
Back to top