Lithium Chip 15.6 Dia x 0.25t mm for Li-ion Battery R&D 100g/bottle (4000pcs) - Lib-LiC25

Lithium chip is widely used for Li-ion and Li metal rechargeable battery R&D, Please click link below to see a paper published in Nature Communication" which use MTI metal foil at the link below

Lithium Chip 15.6 Dia x 0.45t mm for Li-ion Battery R&D 150g/bottle - EQ-Lib-LiC45  

• High rate and stable cycling of lithium metal anode By Jiangfeng Qian, Wesley A. Henderson, Wu Xu, Priyanka Bhattacharya, Mark Engelhard, Oleg Borodin & Ji-Guang Zhan
  

 

SPECIFICATIONS:

Purity	99.9% Lithium
Melting Point	180.5 °C
Density	0.534 g/cm3
Color	Silver
Dimension	15.6mm x .25mm (diameter x thickness)
Net Weight	100g/bottle (around 4000pcs/bottle)
Sealing	Chip sealed in Al can which is vacuum-sealed in Al bag
Shipping Limitations	Shipments of lithium foil are described as “UN 1415, Lithium, 4.3, PG I".   All shipments are Hazard Class 4.3 and require “Dangerous when wet” labels. Sea Class 4.3 (IMDG)  Road, Rail Class 4.3 11a (RID/ADR)
Safety Data Sheet
Operation	Package must be open inside a glove box with Argon Gas and moisture less than 2%RH. May need a screwdriver to help open the AL can, be careful not cutting the gloves. After open the can ,please divided into small package and use a sealed unbreakable bottle/bag for safety Storage. Operation and Storage: Lithium is very active in the air, please carefully read the SDS carefully. Clean the surface of the lithium foil using a nylon brush/stainless steel scalpel until a shiny silvery surface appears (inside an argon glovebox).
Notes	MTI only sells Li chip within the USA and does not accept international order due to restrictions on hazard material exportation!!! MTI reserves the right to charge additional handling fee due to special shipping/handling requirement. Lithium Chip may be oxidized during handling and storage.  if you find any oxidation on the surface of Li-chip,  please use sand paper to remove it before using. Chips will have passivation layer, from our customer experience, remove the passivation layer will increase your battery capacity If the Li metal is stored in mineral oil, please refer to this guide on How to clean mineral oil off Lithium metal using anhydrous Toluene The lithium chips were packed in the dry room with <2%RH. Therefore, slight increase of O2 PPM level might be seen in the glove box when the can is opened. Please keep purging the glove box with ultra-high purity Ar until required O2 PPM level is reached.
Video	Video: How to make solid state battery

Lithium Storage Options

 

Vacuum-able Desiccator with Pump - EQ-SP-VC-3

53L Stainless Steel Vacuum Chamber for Sample Storage ( 16x13x14" ) -- SVC-6050

Compact Stainless Steel Vacuum Glove Box (22"x17"x16") with Vacuum Flange & Gauge - EQ-VGB-1